Bradford white water heater gas valve electronic fault my bw water heater is about 5 years old.
Hot water heater gas valve electronic fault detected.
To check this you will first want to check the pilot flame.
The most common rea.
It may be necessary to temper incoming water supply.
Combination thermostat gas valve set too low for desired water temperature.
The pilot is the most common reason for a lack of hot water.
The water heater s gas valve is located near the bottom of the unit and connects to your home s natural gas line.
2 extremely cold water going into the heater will decrease the amount of hot water produced.
Turn the water heater s gas valve switch to the off position wait for a few seconds and then flip the switch to the on position to reset the system.
A faulty gas pilot gas valve or thermostat are the three most common problems in this situation.
Turn the gas control dial to off and let sit for one minute.
If it s operating correctly then this isn t the cause.
Water heater problems that may be caused by the gas control valve include a faulty hot water heater thermostat faulty gas valve pilot light that won t light and tripped heat limiter.
Turn off the gas supply valve to your appliance to test whether your valve is capable of shutting down properly.
Here s what you need to know about replacing your water heater s gas control valve.
This video provides step by step repair instructions for replacing the gas valve and thermostat assembly on an ao smith gas water heater.
When the circuit board in the gas valve detects the water too hot situation it writes something into static memory in one of its chips and the valve will never work again unless you can manage to reset it as described below.
It could be the gas pilot valve.
8 reset gas valve this will only appear after the gas valve has been shutoff and continues to produce a current to the thermopile.
If the pilot remains lit you will need to replace the gas control valve.
Not enough hot water.
Set the thermostat or the device s controller slightly above the current room temperature.
Cold inlet water temperature is very cold.
Wife and kids were showering and complained hot water was a bit lacking so i turned the temp from baseline hot to hot level a.
Locate the hot surface igniter and look for a spark or glow there.
